Do you want to learn how to get reclaim out of a pipe?

There are many things to consider, but people end up making mistakes by rushing. As long as you take your time to learn and follow the steps, you will be fine.

Here are the main steps to keep in mind.

1) Start Scraping

The first thing you are going to want to do is to get the upper layer out of the way. This can be done with a small pin that you can use to chip away at the resin.

This will help alleviate some of the additional work that would be needed later on.

2) Place Pipe In Isopropyl Alcohol

It is time to start working on the alcohol as that is what you will need for the resin. 99% isopropyl alcohol is a must for this task. Do not go for a weaker concentration as it will not have the same impact.

3) Add Salt

You will want to add salt to the mixture before sealing the bag. The salt is going to improve the potency of your mix and make the alcohol work better.

All you need is a tablespoon of salt to do the trick.

4) Seal The Bag

You are going to want to wait for at least 2-3 hours at this point. This will allow the mixture to work its magic and get rid of the resin build-up as soon as possible. Once you have waited for at least 2-3 hours, you can start to shake the bag.

By shaking the bag, you can get the alcohol into areas that it wasn’t before.

This is key in getting the resin to shake loose and not ruin the pipe.

5) Rinse With Warm Water

At this stage, you can take out the pipe and start to take it to your sink. Use warm water and make sure to rinse the mixture off of the pipe vigorously.

This should do the trick and make sure the pipe is ready for use again.

Try to do this every week for great results and consistent value.

As long as you focus on these steps, you will be well on your way to a cleaner pipe. With these steps on how to get reclaim out of a tube, it’s all about staying patient and making sure you put your best foot forward by following instructions.